Middle Pin Came Off From Pollak 7-Pole Trailer Connector
Updated 02/13/2018 | Published 02/12/2018
Question:
I have the above part number as the middle metal piece came off. How can you tighten it up?
asked by: John T
1
Helpful Expert Reply:
I spoke with my contact at Pollak regarding your 7-Pole Trailer Connector # PK12706. He stated that If the center pin broke/came off from the connector, the entire connector should be replaced. There isn't really a way to securely re-attach the pin if it broke off from the connector.
expert reply by:
Chris R
1
Product Page this Question was Asked From
Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How To Plug 1997 Lance Truck Camper Into 7-way Connector On 2016 Ford F-250
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Q&A: What Brand are the BK3-200 Bearing Kits
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Bearings and Grease Seal for Terran Axle Idler Hub
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Wiring An Electric Trailer Tongue Jack Into 7-Way Vehicle Trailer Connector
- Q&A: Parts Needed to Flat Tow 2025 Lincoln Nautilus Hybrid
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Rust Prevention