Are Rotating Dexter EZ Flex Suspension Wet Bolts an Issue
Updated 02/05/2018 | Published 02/03/2018 >
Products Featured in This Question
Question:
While replacing the brakes on my 2014 Cedar Creek Fifth Wheel 31RK I decided to lube my Dexter EZ Flex suspension bolts. I noticed a couple of the link bolts would rotate even though they did not feel like they needed to be tightened. I lubed everything without any issues. Is this typical or a symptom of something I need to address. Thanks
asked by: Mike M
Expert Reply:
Although the wet bolts have splines to help prevent them from rotating (see attached picture), it is not crucial that they remain still.
If they feel like they are tightened properly and they don't seem to be worn out then you will be good to go. Otherwise you can replace them with part # 018-026-05 on our site.
Product Page this Question was Asked From
Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs
- Trailer Suspension Parts
- Equalizer Upgrade Kit
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 5-5/8 Inch Long
- Tandem Axle
- Dexter
more information >
Continue Researching
- Shop: Center Hanger for Double-Eye Springs - 5-7/16" Tall - 3/4" Bolt Hole
- Shop: Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 4-1/4" Tall - 9/16" Bolt Hole
- Video: All About the Center Hanger for Double-Eye Springs
- Shop: Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double-Eye Springs
- Q&A: What is Bolt Hole Diameter for Suspension Hanger # E4139
- Shop: Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 6-1/8" Long - 9/16" Center Hole
- Video: Review of the Suspension Kit for Tandem-Axle Trailers
- Video: All About the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers
- Q&A: Where is Trailer Suspension Equalizer Length Measured
- Q&A: Bolt Grade of Hardware that Comes with the Suspension Kit for Tandem-Axle Trailers AP233
- Q&A: How Thick is Center Trailer Suspension Hanger # 115919
- Video: Front/Center/Rear Hanger for Double-Eye Springs: The Breakdown
- Shop: Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 7-3/4" Long - 3/4" Center Hole
- Shop: Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs - 2-1/4" Links
- Q&A: Aligning a Trailer Axle with the Center Bolt on a Spring
- Q&A: How to Determine Weight Capacity of Trailer Axle
- Q&A: Outside Width Dimension of the Redline Trailer Hanger # E4139
- Video: In-Depth Review of the Shackle Bolt for 1-3/4" Wide Double Eye Springs
- Video: What to Know About the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers


