Is Drilling Required to Install JT's Strongarm Kit # LC191023
Updated 01/31/2018 | Published 01/30/2018
Question:
Is drilling into the frame required for the installation of the JTs Strong Arm system?
asked by: Jeff L
0
Expert Reply:
Yes, there will be drilling into the frame with the included self tapping screws to install the JT's Strongarm kit part # LC191023 that you referenced.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ 58" or More Between Landing Gear
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- Manual Jack
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: JT's Strong Arm Jack Stabilizer Kit For 2020 Grand Design Reflection 31MB
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Q&A: Recommended Class IV Hitch for a 2012 Chevrolet Silverado 1500
- Q&A: Travel Door Latch for 9.8 Cu. Ft. GE Appliances RV Refrigerator with Top Freezer
- Q&A: Installing JT's Strong Arm Jack Stabilizer Kit on 5th Wheel Trailer without Crossmember
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How Much Solar Power Do I Need For My RV?
- Article: Still Rocking After Leveling? How to Stabilize Your RV for Good
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Best Bike Racks for Electric Bikes
- Article: How to Measure Your Trailer Wheel Bolt Pattern