Recommendation For Replacing Leaf Springs And Hangers

Published 12/01/2017

Products Featured in This Question

2-Leaf Slipper Spring w/ Flat End for 1,800-lb Trailer Axles - 30" Long

(285)

$48.48

Single-Axle Trailer Hanger Kit for 1-3/4" Slipper Springs - 1-1/2" Tall Front

(125)

$39.46

CE Smith U-Bolt Kit for Mounting 1-1/2" Square Trailer Axles - 3-3/8" Long U-Bolts - Zinc

(1028)

$28.96

Question:

Looking for a leaf spring/ hanger kit. I could send a pic if you get back to me.

asked by: Bill

Expert Reply:

I am glad to make a recommendation for your needs based on the pictures and information you sent. We have a few options to consider for a 30 inch long leaf spring that is 1-3/4 inches wide.

For an 1,800 lb axle that has 2-Leaf Slipper Spring with flat end option, you would use Item # e29SR.

For a 2,900 lb axle that has 3-Leaf Slipper Spring with flat end option, you would use Item # SP-039275.

A U-Bolt Kit for a 1-1/2 inch wide square axle for 1-3/4 inch springs is Item # CE23102.

A Trailer Hanger Kit for 1-3/4 inch springs is Item # APS3SE.

Depending on your axle capacity and total gross weight of boat on trailer, you could use a 2-leaf or 3-leaf option. You do not want to get springs that are too heavy for your axle so check your axle rating. If it has a higher capacity like 3,000 lbs then the 3-leaf springs would be a better choice. The key is to make sure the springs are not too heavy for the axle so that they flex.

All springs should be replaced at the same time to provide ideal support for your trailer so that you get the maximum benefit and best ride from the springs.

Additional information attached.