How Do Switches of Ventline Ventadome Roof Vent # V2119-1-533 Wire Up
Updated 11/28/2017 | Published 11/27/2017
Question:
Please provide a schematic to install the two switches. Thanks
asked by: Delbert D
0
Expert Reply:
There really isn't much to wiring up the switches. Basically each switch gets installed on either the power or ground circuit for the fan motor or lift motor so that when the switch is off the circuit is off and when it is on the circuit is completed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ventline Ventadome Roof Vent w/12V Fan and Wall Switch - Powered Lift - 14-1/4" - White
- RV Vents and Fans
- Vent
- Roof Vent
- Powered Lift
- 12V Fan
- Plastic and Metal
- White
- Ventline
more information >
Continue Researching
- Q&A: How to Determine the Correct Replacement Wiper Seal For an RV Slide-Out
- Q&A: How to Choose the Correct Valterra EZ Valve Electric Waste Valve for RV Black Water Tank
- Q&A: Recommended Electric RV Awning Conversion Kit for a Dometic A&E 8500 Series Manual Awning
- Q&A: Will Bargman # 47-86-202 Replace # 48-86-202
- Q&A: How to Determine Correct Ball Mount Drop For Toyota Highlander With 2 Inch Hitch
- Q&A: Difference Between the Camco RV Vinyl Insert 25212 & 25312
- Q&A: Replacement Hub and Drum assembly for ALKO 8480
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: How to Replace or Install an RV Roof Vent
- Article: Trailer Hitch Installation Tips
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Converting Your RV Water Heater to Tankless
- Article: Determining Trailer Tongue Weight
- Article: How to Measure for Motorhome Steps