Length of Short Arms Included with Lippert JT's Strong Arm Jack Stabilizer # LC191024
Updated 10/18/2017 | Published 10/17/2017
Question:
Hello...What is the length of the short arms in this kit? Closed and open size. Already found the length of the long arms in another QandA. Thanks
asked by: S. F
Expert Reply:
The shorter arms included in the Lippert Components JT's Strong Arm Jack Stabilizer # LC191024 measure 21-3/4 inches retracted and just about 43 inches when extended. This measurement is from the center of one hole to the center of the other.
This kit will include four stabilizer tubes for the front of the coach and two for the rear. It will also include all of the hardware necessary for installation.
Product Page this Question was Asked From
JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ Less Than 58" Between Landing Gear
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- Manual Jack
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: Recommended 1-1/2" Square Axle w/a 49-1/2" Hub Face and 5 on 4-1/2 Lug Nut Pattern Hubs
- Q&A: Will MORryde X-Brace Stabilizers Fit A 5th Wheel Trailer With Round Tube Jacks
- Q&A: Attaching JT's Strongarm Stabilizers to 2019 Grand Design Momentum Toy Hauler with Levelup
- Q&A: Furrion Chill Cube With Heat Pump For 2019 Jayco North Point 377RLBH
- Q&A: What is the full extend height of Bigfoot 8K Hydraulic Tongue Jack for Bumper Pull Trailers?
- Q&A: Swing Away Bike Rack For Carrying 2 E-Bikes On A 2020 Winnebago Travato KL
- Article: How to Raise Your Travel Trailer Height
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Wiring Diagrams
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Converting Your RV Water Heater to Tankless
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box