Could CE Smith Galvanized Steel Step # CE26212G-15284GA Be Used on 3 inch Wide Frame
Published 10/12/2017
Question:
Id like to mount these on my trailer tongue which is 3 x 5 do you have u bolts that will fit? I looks like the mounting slots are wide enough. Otherwise, do you have a galvanized strip with 3 inch hole spacing so that bolts could be used? Thanks,
asked by: Cal
0
Expert Reply:
What you can do instead is get the # CE26212G, and then purchase the U-bolts you need to fit your trailer. We don't have any for a 3 inch frame width, but as long as the bolt is 9/16 or 1/2 inch diameter it will work in the slotted mounting holes.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CE Smith Galvanized Steel Step for Trailer Fender - 15-1/4" Long x 3" Wide - Qty 1
- Boat Trailer Parts
- Steps
- 15-1/4 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: What mounting hardware would I need to install CE Smith Single Axle Trailer Fenders?
- Q&A: What Bracket Kits Will Allow CE 19504-2 Fenders To Mount To Shorelander Boat Trailer?
- Q&A: How Does the CE Smith Single Axle Trailer Fender Attach to the Trailer?
- Q&A: Is The Tie Down Plastic Fender TD86VR Sold As A Pair Or Single Fender?
- Q&A: Hardware for Installation of CE Smith Single Axle Trailer Fenders
- Q&A: Using Two Bow Stops on Either Side of a Boat Trailer Winch
- Q&A: How Do The etrailer Single Axle Trailer Fenders Install?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Boat Trailer Guides: Which are the Best?
- Article: Rust Prevention
- Article: How to Mount a Truck Bed Camper
- Article: Trailer Lighting Requirements
- Article: Hand Winches