Dimensions of the etrailer Steel Trailer Fender # HP76VR

Updated 05/18/2011 | Published 05/16/2011

Question:

Does the width of this fender taper? On you page it says 10 wide and now I read that the top width is 8 1/4 wide. so its not 10 wide all around? Its narrower at top than bottom? Thanks,

asked by: John S

Expert Reply:

I went out in the warehouse and measured the etrailer Steel Trailer Fender, part # HP76VR. If you measured the width of the fender including the radius lip portion of the fender it is 10 inches wide everywhere. It is not narrower at the top.

The 8-1/4 inch width is if you just measured the flat portion of the width not including the radius lip.

See photo of the fender I am including that will show the measurements on the fender.

expert reply by: Jeff D