Size of the Ends of the Bow Roller Assembly w/ Bells # YR450Y-400Y
Published 09/22/2017
Question:
What is the diameter of the two end caps on the 4inch roller?
asked by: Jake J
0
Expert Reply:
One the Bow Roller Assembly w/ Bells # YR450Y-400Y the diameter is 5-1/4 inches at the widest point and 3-1/2 inch where it attaches to the shaft. The shaft diameter it is designed is 1/2 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bow Roller Assembly w/ Bells for 4" Wide Bracket - TPR - 1/2" Shaft - Yellow
- Boat Trailer Parts
- Rollers
- Bow Roller
- 3-1/4 Inch Diameter
- Plastic
- 3-3/4 Inch Long
- Yates Rubber
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Comparing PVC, TPR, and Polyurethane Boat Rollers
- Q&A: Bow Roller Assembly w/ Bells # YR450Y-400Y Center Roller Width
- Q&A: How To Install a Battery On a Trailer for Use with Electric Jack
- Q&A: Replacement Carbon Monoxide Detector for Atwood 36681
- Q&A: Mounting Hole Dimensions of Dutton Lainson Sidewind Jack # DL22339
- Q&A: Replacement Inner Member Assembly for UFP A 60 Surge Brake Coupler
- Q&A: Correct Replacement for UFP H-1377 Trailer Hub
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Boat Trailer Guides: Which are the Best?
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Lighting Requirements