Parts Needed to Install Brake Controller in 2017 Ford Escape with Factory 4-Way

Published 08/18/2017

Products Featured in This Question

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3397)

$121.27

Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional

(2763)

$151.23

Question:

I have a Tekonsha P3 brake controller in our van that Id also like to use on my 2017 Ford Escape that came with the factory 4-wire towing connector/tow package. What do I need to install the appropriate wiring needed for the brake controller to work on the Escape? Obviously I need a 4/7 connector to replace the factory 4-pin connector, but what about the wiring/mount for the P3? Thanks.

asked by: Rob C

Expert Reply:

You would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want the Brake Controller Install Kit and 7-Way Adapter part # ETBC7. I attached installation instructions and an install video for this product as well. This does not replace your 4-way. Actually your 4-way plugs into this and gives you the rest of the wiring needed to install the connector and wire in the brake controller.

For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.

expert reply by: Jameson C