Parts Needed to Install a 7-Way Trailer Connector on a 2011 Toyota Highlander

Updated 04/06/2011 | Published 04/05/2011

Products Featured in This Question

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(940)

$53.12

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3349)

$109.28

Question:

Do you have wire kit for 7-way connector for 2011 Toyota Highlander? What should I do to fix it dirtectly outside on the hitch? Thank you for your help

asked by: Luc L

Expert Reply:

To add a 7-Way trailer connector to your 2011 Toyota Highlander, you will want to start with adding the Tow Ready Custom Fit Vehicle Wiring, # 118449, that you have referenced, if the vehicle does not already have a 4-Way connector.

In order to have the 4-Way underneath the vehicle, you will need to find a grommet in the bottom of the cargo area, route the plug through it and out to the rear of the vehicle. Make sure to seal up any holes that you may have had to make to route the harness.

With the 4-Way at the back, you can then add 4 and 7 Way Installation Kit, # ETBC7. The 4-Way plugs into the back of this harness leaving only 4 wires to hardwire. It comes with a mounting bracket and you can install it with the included self-tapping screws in a convenient location. I have included 2 FAQ articles and a video that explain how to install an ETBC7 kit.

expert reply by: Michael H