Installation Of The Rear Jack On The Lippert RV Leveling System Part # LC358590
Updated 06/26/2017 | Published 06/24/2017
Question:
It seems like at the exact 20 ft. Measurement on my Raptor 297s toyhauler is within the rear step assembly. Cannot be mounted on the outside of the I Beam. Not enough space between the beam and step assembly. Can it be mounted on the inside rather than outside of the beam?
asked by: Ken H
Expert Reply:
The recommended placement of the rear jacks on the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC358590 is 1 foot behind the rear tires, parallel with one another. If there is insufficient space on the outside frame rail at this location then yes, the rear brackets can be mounted to the inside of the frame rail. However, Lippert recommends using the outside of the frame rail for increased support.
The installation process is fairly straight forward as the landing gear will mount to the existing holes from your current landing gear setup. You will need to drill into the frame in order to install the rear jacks.
I have included a video review of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System for you.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Does etrailer Carry Andersen Ultimate Safety Chain Attachment
- Q&A: Replacement Front Jack for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Lippert Ground Control 3.0 Leveling System For A Prepped Forest River Wolf Pack 315PACK12
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: Can I Grease or Lube the Inside of My Lippert 3.0 landing Gear?
- Q&A: Can 5,500 RPM Landing Gear Motor for Camper be Upgraded to Faster Setup
- Q&A: Advantage of 4 Point Lippert Ground Control Kit Over 6 Point
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices