Availability of Boat Trailer Roller Endcap That is 2-1/2 inches Wide and has a 3/4 inch Bore
Published 06/22/2017
Question:
I need a trailer roller end cap 2.5 inches wide with a 3/4 inch bore. Do you have anything like that?
asked by: Jim P
0
Expert Reply:
The closest end cap that we have to the 3/4 inch bore that you referenced is made to fit 5/8 inch shafts. The Yates Endcap # YR224-5 has a diameter of 2-1/2 inches and is 2-1/2 inches wide.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Yates Endcap for Side Guide Rollers - Heavy-Duty Rubber - 5/8" Shaft - Qty 1
- Boat Trailer Parts
- Rollers
- End Cap
- 2-1/2 Inch Wide
- 2-1/2 Inch Diameter
- Rubber
- Fits 5/8 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: How Much Roller Shaft Length will Yates Endcap for Side Guide Rollers # YR224-4 End Up Taking up
- Q&A: Replacement 6" x 2" Roller for Older Boat Trailer
- Q&A: Roof Rack For Carrying Two Tooenjoy Lift Assist Racks On A 2015 Toyota 4Runner
- Q&A: Will Malone AirFlow2 Roof Rack Fit 2017 Toyota RAV4 With Raised Rails & Hold Rooftop Tent
- Q&A: Replacement Axle Options For a 2024 Nucamp Tab 400 BD Teardrop Camper
- Q&A: Are the Loadstar 4.80-12 Bias Trailer Tire and the CE Smith Offset Spare Tire Mount Compatible?
- Q&A: How to Cut Dutton-Lainson Boat Trailer Guide-On Roller # DL21554 Down to 8 Inches
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Lighting Requirements
- Article: Troubleshooting Brake Controller Installations
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Accurately Measure Trailer Leaf Springs