Fender Back Recommendations for a Trailer Fender # HP29VR
Updated 03/09/2011 | Published 03/07/2011
Products Featured in This Question
Question:
Do they make a fender back that will fit a F1075x32-1R fender.
asked by: Scott P
0
Expert Reply:
Yes, you could use a Pre-Cut Fender Back for Redneck Trailer Fender, part # 10FB-32R.
Or if you wanted a fender back that is slightly wider you could get a Pre-Cut Fender Back for Redneck Trailer Fender, part # 12FB-32R.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Single Axle Trailer Fender for Enclosed Trailers - Cold Rolled Steel - 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 15 Inch Wheels
- 10-3/4 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement Weld on Trailer Jack for a Phoenix Boat
- Q&A: Troubleshooting Trailer Tires Getting Broken Belts On 14,000 GVWR Trailer
- Q&A: Wiring Diagram for the Dometic Replacement Single Zone Thermostat
- Q&A: Repair Kit for 12000-lb-Rated Bulldog Square Tube Jack
- Q&A: Replacement Spring for Bulldog Sidewind Jack with 12000-lbs Capacity
- Q&A: How To Bolt-On, Weld On Trailer Fenders
- Article: Most Popular Wheel Bearings
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: Hitch Mounted Cargo Carrier Information