Is Trimming Of Air Dam Required For 2-Inch Receiver On Fornt Mount Hitch On 2017 Toyota Tacoma
Updated 05/16/2017 | Published 05/14/2017 >
Question:
You show trimming 5.25x1.5 and 5.625x1.5 on the air dam I assume are for the tow hooks. How about for the 2x2inch hitch opening? Is trimming required for it on the air dam?
asked by: Bill P
Helpful Expert Reply:
I called my contact at Curt and asked about the installation of the front mount hitch # C31075 on your 2017 Tacoma. The two places you mentioned need to be trimmed on the front air dam, but the receiver sits below the air dam so no further trimming is needed to accommodate the 2-inch receiver.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 350 lbs Vert Load
- 3500 lbs GTW
- 9000 lbs Line Pull
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Front Mount Hitch
- Q&A: Where Does the Air Dam Get Trimmed to Install Curt Front Receiver on a 2016 Toyota Tacoma
- Q&A: Do all Front Hitches for 2019 Toyota Tacoma have Tow Hooks in Front
- Q&A: Will Ground Clearance be Reduced with Front Mount Receiver Installed on a 2017 Toyota Tacoma
- Q&A: 2024 Toyota Tacoma Trailer Towing Mirrors Recommendation
- Q&A: Recommended Snow Plow for 2014 Toyota Tacoma 2WD
- Q&A: Recommended Wiring Harness For 2020 Toyota Tacoma Towing A Trailer
- Q&A: is EcoHitch Front Hitch Compatible With TRD Skid Plate On 2022 Toyota Tacoma TRD Pro?
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Hitch Installation Tips
- Article: Performance Chips and Modules
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Wiring a Tow Vehicle to Tow a Dinghy
- Article: How Much Does a Boat and Trailer Weigh?
- Article: How to Measure for Trailer Hitch Drop

