How to Gain Clearance Between Tailgate and A-Frame Sidewind Trailer Jack

Updated 05/10/2017 | Published 05/09/2017

Products Featured in This Question

Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs

(990)

$87.42

Brophy Ball Mount - 3" Rise, 4" Drop - 14-5/8" Long - Aluminum - 8,000 lbs

(156)

$100.34

Question:

I have a tailgate clearance problem with the sidewind A-Frame jack on my trailers tongue. Its only the crank handle on the jack that interferes. I am considering replacing the jack to solve the problem. A topwind jack with a handle that would fold back would likely solve the problem but I would actually prefer the sidewind design. Do any of your sidewind jacks allow the crank to be re-oriented 90 degrees to the side or other orientation instead of being on the front of the jack? Thank you!

asked by: Aaron Y

Expert Reply:

An A-frame trailer jack like # TJA-5000S-B can be position in any orientation. So the handle can be installed facing the rear if you'd like.

Another solution that may work for you is a longer ball mount. We have the Brophy # EA40 which is 14-5/8 inches from the hitch pin hole to the ball hole. This will move the entire trailer back from the tailgate.

expert reply by: Charles S