Can a 2-1/2 Inch Round Surface Mount Trailer Light be Mounted Using a Grommet Instead
Updated 04/11/2017 | Published 04/09/2017
Products Featured in This Question
Question:
can you use the rubber gromit with this light ? thanks
asked by: Charles J
1
Helpful Expert Reply:
Technically you could use grommet # A57GB with trailer light # MC58RB. However the light was meant to be attached to a flat surface. The recessed mount version is # MC55RB and you would use grommet # A55GB. This set up actually costs a little less though the light requires pigtail # A46PB.
expert reply by:
Michael H
1
Product Page this Question was Asked From
2-1/2" Round Trailer Clearance and Side Marker Light, Surface Mount - Red
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 2-1/2 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Kwikee Step Motor 1101423
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: Replacement 2-1/2 Inch Red and Amber Clearance Lights for 2018 Kodiak Travel Trailer
- Q&A: Replacement Steps for Lippert 171317
- Q&A: Replacement Electric Folding Steps For Lippert LCI 128980 Coachstep
- Q&A: Replacement Parts for Lippert RV Steps 171317
- Q&A: Recommended Replacement Marker Lights For a Vintage Trailer With 2-1/2" Round Lights
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: My Trailer Hitch Doesn't Fit
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups