Installing Ground Wires of Roadmaster Tail Light Bulb Kit for a Flat Towed Vehicle
Updated 03/23/2017 | Published 03/22/2017
Products Featured in This Question
Question:
the instructions and video has the white grounding wire being daisy chained together and then a single grounding wire being attached to the car body/frame. Wiring a 07 jeep wrangler and prefer to just wire each lights ground to the body in side each of the tail light mounting locations.
asked by: Chase M
0
Expert Reply:
Generally, when installing # RM-155 the ground wires are combined and connected to the vehicle frame in one location. However, as long as you're using a good, clean mounting point the grounds can be connected on each side.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Roadmaster Bulb and Socket Set for Tail Light Wiring Kits - Incandescent - Qty 2
- Flat Tow Wiring Harness
- Bypasses Vehicle Wiring
- Bulb and Socket Kit
- Universal Fit
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Klauber A-300 Motor For RV Slide Out.
- Q&A: Replacement Motor for Klauber Slide Out Motor K01431B300
- Q&A: Replacement Control Module For Control Module 346005 On 6-Point Lippert Ground Control
- Q&A: Will Blue Ox Bulb and Socket Tail Light Wiring Kit for Towed Vehicles Work on My 2024 Jeep Gladiator
- Q&A: Can the Furrion Chill Cube Be Used to Replace a Ducted Dometic AC
- Q&A: How to Wire the 4-Way Round Socket for the Blue Ox 7-Wire to 4-Wire Adapter # BX88254
- Q&A: Replacement Thermostat for Dometic 3316410.012
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Trailer Wiring Diagrams
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 2012-2014 Honda CR-V