Replacement Lid Recommendation for Camco Roof Vent CAM40480

Question

Question:

Hi do you sell a replacement lid for # CAM40480, thx

asked by: Doug D

1

Helpful Expert Reply:

The replacement lid you need is the part # BV0554-01 which is a fit for the # CAM40480 that you referenced.

expert reply by: Jameson C

1

Answer 1

Hello James, I am very sorry to hear that your trailer was damaged by the hurricane, I hope there is not too much other damage that needs repairing. Glad you are OK and able to write in. For sealing the new metal panel to your cargo trailer’s roof,…

view full answer...

Answer 2

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 3

Good morning, Don. The 3/4" wide butyl tape is exactly what we recommend for installing a roof vent such as the MaxxFan #MA00-07000K. We actually sell a roof vent install kit part #344270KITW that comes with sealant, screws and a 30' roll of…

view full answer...

Answer 4

Denise, the universal Brandmotion Wireless HD Observation Camera System #BM37SR system is built for long-body RVs and works with up to 80 feet of range, more than enough for your 38' 5th wheel. It uses a 2.4 GHz digital link, so you’ll get a…

view full answer...

Answer 5

You do not want to use the ASA to replace your duo therm. You're going to want to replace it with a Dometic unit #DMC33ZR instead.

view full answer...

Answer 6

Yes, you are absolutely correct. In order to use the Thule Mounted top Rack System #THTB60 or #THTP54 with the WingBar Evo Crossbars #TH711220, you will need the following parts: - Rapid Podium Feet for Thule Crossbars - Fixed Point #TH460R - Fit Kit…

view full answer...

Answer 7

The standard battery size for a breakaway system is 5 amp hours. I recommend the Hopkins Engager Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger part #20400 which is a complete kit that has everything you need. It also have a cool…

view full answer...

Answer 8

The battery you use for a break away system needs to be able to power the trailer brakes on full for 15 minutes. A 12 volt battery rated for 5 amp hours is normally used, unless you have 3 axles each with brakes, then you would benefit more from a 9…

view full answer...

Answer 9

One thing to note when using a hitch extender like the etrailer, #e88YR, is that the tongue weight and towing capacity of your trailer hitch will be reduced by 50 percent due to the increased leverage that is placed on your trailer hitch from your…

view full answer...

Answer 10

Hey Rodney, For a rubber roof you can use the Alpha Systems 1021 Self-Leveling Sealant for RVs #AL98KV. This is self-leveling sealant so it's design to pool a bit before drying and would only be good for use on the roof. If you're needing any…

view full answer...

Replacement Lid Recommendation for Camco Roof Vent CAM40480

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching