Is The Ball Mount Included With The Curt Class II Drawbar # C45520 For A 2003 Toyota Camry

Updated 01/26/2011 | Published 01/25/2011

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(102)

$436.95

Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1

(679)

$16.44

Curt Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-1/4" Long - 3,500 lbs

(2327)

$38.79

Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span

(2973)

$4.09

Question:

Is Ball Mount D20/45520 Included in the price shown. This is for Hitch Model #12339 for 2003 Camry.

asked by: Ron A

Expert Reply:

Yes, the Curt Class II Drawbar, part # C45520, is included with the Curt Class II 1-1/4 Inch Hitch, part # 12339, for your 2003 Toyota Camry. It will also include the Curt Class I and II Pin and Clip, part # F-4. I am including a link to a video of this Curt hitch being installed on a 2003 Toyota Camry.

To complete your towing setup, you will also need the Tow Ready 2 Inch Hitch Ball, part # 19258, or the Tow Ready 1-7/8 Inch Hitch Ball, part # 19256 and the Tow Ready T-One Wiring Harness, part # 118308. See link at bottom of page of the installation instructions for the T-One wiring harness.

If you will be using the Curt hitch for a non-trailer load like a bike rack or cargo carrier you will need to use a stabilizing strap like the Curt Bike Rack Strap, part # 18050. It is required by the manufacturer (Curt) to give extra support to the hitch accessory. Failure to properly support these loads will void your hitch warranty from Curt.

expert reply by: Jeff D