Can Drilled Out Yakima Lock Core be Replaced

Question

Question:

Hi, Im looking at a roof cargo box, I havent bought it yet, that has its lock drilled out. Can that be replaced and what new cylinder core will I need to replace it? Thanks,

asked by: Brett B

0

Expert Reply:

It's hard to see in the picture if the lock assembly is damaged, but if the housing is okay you could install a new core with the part # Y07202.

Seeing the core drilled out like that does warrant some questions though...like was the box stolen? Did he lose the key? You might ask a few questions.

expert reply by: Jameson C

0

click to enlarge

Answer 1

To replace the latch on the Yakima SkyBox 18 Rooftop Cargo Box item #Y07336 you will want the Replacement SuperLatch Handles for Yakima SkyBox Cargo Boxes item #Y8880348. This comes with two latches so that you can replace both and have matching lock…

view full answer...

Answer 2

The only way to remove a Yakima SKS lock core without damaging the core is with the control key. If you lost the control key, we offer a replacement key as part #Y8007835. Your only other option would be to either have a lock smith attempt to pick…

view full answer...

Answer 3

Based on what you are describing it sounds like both of the latches need to be replaced. The correct replacement part is the Replacement SuperLatch Handles for Yakima SkyBox Cargo Boxes - Qty 2 #Y8880348. I would try replacing the latches and go from…

view full answer...

Answer 4

Hi Chris, It sounds like you've found yourself in a bit of a pickle but you're on the right track. If the key broke off in the lock, the easiest solution is to replace the entire Replacement SpeedKnob and Wedge Assembly, Part #8880508. That…

view full answer...

Answer 5

Thanks for the photo, and we have been told previously by Yakima that you can indeed change out the lock cores on the older cargo boxes with the SKS system, so you can use the Yakima Same Key System (SKS) Lock Cores #Y07202.

view full answer...

Answer 6

You're correct, the Yakima OverHaul HD ladder racks like part #Y01151-58 only come with two locks. The towers lock into bases and these bases are what the locks attach to. The intention is that you would use one lock base on each set of towers to…

view full answer...

Answer 7

It sounds like your Skybox has already been tampered with as this is not normal at all. I recommend you replace the entire assembly using the Replacement SuperLatch Handle Assemblies for Yakima SkyBox Rooftop Cargo Boxes - Qty 2 #Y8880348. These…

view full answer...

Answer 8

The correct replacement handles for a Yakima SkyBox made from 2009 on is the Replacement SuperLatch Handle Assemblies for Yakima SkyBox Rooftop Cargo Boxes #Y8880348. These come in a quantity of two with lock cores and keys, so you have the right…

view full answer...

Answer 9

It truly depends on what bike rack you have and what key code you have with the locks. If the key you have doesn't turn the lock, it most likely is not the correct key for the rack. The best way to proceed is to make sure the key you have matches…

view full answer...

Answer 10

Any SKS lock core would technically fit the Yakima Jaylow Kayak Carrier part #Y04073 but we have a kit that comes with two cores that would work well as the part #Y07202. This will give you a pair of cores that match but aren't going to be the…

view full answer...

Answer 11

Yes, Yakima cargo boxes like the SkyBox #Y07337 fit the Thule ladder rack #TH500XT. The hardware can accommodate a bar that is 3-1/2 inches wide which is what the Xsporter bars on the ladder rack are.

view full answer...

Answer 12

Hey Mark, welcome back! This is very much a case of "you get what you pay for." The Curt TruTrack 2P #C95MJ you looked at is a good option if you tow your trailer a short distance once or twice a year. If you tow with any frequency and you…

view full answer...

Can Drilled Out Yakima Lock Core be Replaced

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching