View Cart

CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10455G Review

content loading



Customers compare CE10455G to these similar products




Products Featured in this Video



Review of CE SMIth Boat Trailer Parts CE10455G


Today, were going to review part number CE10455G. This is the C.E. Smith, deep V keel roller assembly for boat trailers. This roller assembly will support your boats keel for easy loading and safe transport on your trailer. Its twelve inch yellow thermal plastic rubber spool rollers will not mark your boat, and the galvanized steel panel bracket has slotted mounting holes for adjustability. Typically installed upright on the rear and middle cross members of a boat trailer, this keel roller panel bracket assembly will help keep the boat moving while it is being loaded and to stabilize the keel.

Has deep V keel roller supports, which will support your boats keel as it sits on the trailer. Itll help ease loading and unloading of the boat. And it helps to absorb road shock while the boats being trailered. The panel bracket lets you bolt your roller assembly on to the front of your boat trailer. It has slotted mounting holes, right here, that let you adjust the position during installation.

When you install it, it does require a half inch or seven sixteenths fasteners, which are not included. The sturdy galvanized steel bracket will resist corrosion. The galvanized steel parts are hot dipped in a zinc, after being stamped. And this will create a coating that is typically three millimeters to five millimeters thick. And this thick all around coating will allow the galvanized steel products to provide years of use without rusting or corroding.

This panel does have gussets. Theres three on each side. Three here, and three over here. And those six gussets will provide extra strength by stiffening the bends. The yellow TPR roller, which stands for Thermal Plasticized Rubber will deliver superior, long lasting performance.

The TPR material is a non-marking, and stronger than rubber and softer than polyurethane. This part is made in the U.S.A. I do want to give you a few dimensions on this. The roller length is going to be twelve inches. This does ride on a five-eighths inch shaft diameter. Now on the mounting holes, the dimensions of the slots are going to be half inch wide and five inches long. The spacing between the slots, centre to centre is going to be ten inches. And the overall size of the whole bracket is going to be twelve inches by about six and a quarter inches. And again, this part is made in the U.S.A. And that should do it for a review on part number CE10455G. End of Audio Duration: 3 minutes, 29 seconds .


Questions and Comments about this Video

add comment

Info for this part was:

Installed by:
Jeff D

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.