Is There Difference Between 2 inch and 2-5/16 inch Ball

Question

Question:

2 inch ball and 2-5/16 is the same ball or different?

asked by: Abraham

0

Expert Reply:

The two sizes you mentioned are different balls. The larger size typically has higher capacities and fits couplers that are designed for it's size. The 2 inch size is typically seen in lighter duty applications. You have to match the correct size hitch ball with what the coupler is designed to fit.

I attached a link to a page that has all of the hitch balls we carry as well.

expert reply by: Jameson C

0

Answer 1

Nothing to worry about, we have cost effective patch kits to help with your situation so you that you will not have to replace the whole roof. We have the Patch Strip for RV Roof Membranes, #QR27FR that is 6' x 8". And for 20' x 4"…

view full answer...

Answer 2

We can definitely get you set up with a weight distribution hitch for your 2024 Forest River Ibex 19QBS. It has an unloaded hitch weight (also called tongue weight) of 458 lbs like you said, and with a GVWR of 5,328 its loaded hitch weight will be…

view full answer...

Answer 3

Since your trailer is very close to 5,000 lbs your total tongue weight is very likely to exceed the 600 lb capacity of the 6k weight distribution hitch, so what you need is the 8,000 lb hitch, and I recommend the Fastway e2 (which is made by…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Is There Difference Between 2 inch and 2-5/16 inch Ball

Featured Help Information

Miscellaneous Media

Continue Researching