Replacement Trailer Wheel Studs for a 5 on 4-1/2 UFP Hub
Updated 01/04/2017 | Published 01/03/2017
Products Featured in This Question
Question:
I am looking for some stud bolts for a UFP hub. The hub has the number 1377 on it. it is five bolt x 4.5. The bolt has U2Q on the head
asked by: Bob M
0
Expert Reply:
To determine the correct wheel studs you need you're going to have to measure the ones that you currently have. First of all are they drive-in, like # K916WB25 or screw-in studs, like # 25-11?
You'll then need to measure the length and thread diameter. I've linked out selection of both styles for you to match what you currently have.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Kodiak Wheel Bolt - 9/16" Diameter x 2-1/2" Long
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 9/16 Inch Diameter
- Drive-In Stud
- 2-1/2 Inch Long
- Kodiak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can The Alpha Systems Anti-Wicking Adhesive AL97CV Be Used To Seal The Bottom Of A Slide Out?
- Q&A: Roof Adhesive Recommendation for Polystyrene to Plywood Roof
- Q&A: Recommended 7-Way Trailer Connector for a 2014 Ford F-150 w/out the Factory Towing Package
- Q&A: Replacement for TDE 70 Surge Brake Actuator
- Q&A: Whats the Difference Between Spring Return Jack and a Non-Spring Return Jack
- Q&A: Replacement Hub/Drum and Brake Assemblies for Dexter 12k Axle
- Q&A: Should There Be a Washer on Trailer Spindle Between Spindle Nut and Outer Bearing
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch