What Are The Outside Dimensions Of The Steel Rod In The Single Flexguard RV Slide-Out Kit?
Updated 12/19/2016 | Published 12/17/2016
Question:
What is the outside dimensions of the steel rod , is it 1/2 inch ? Thanks
asked by: Joe B
0
Expert Reply:
Lippert Components Single Flexguard RV Slide-Out Kit Hardware, # LC1346271, has a steel rod that is 1/4 inch diameter, 8.09 inches long, and is 2.5 inches on center to the attached bracket. I've attached a picture to help.
expert reply by:
Jason S
0
click to enlarge
Product Page this Question was Asked From
Lippert Components Single Flexguard RV Slide-Out Kit Hardware
- RV Slide Out Parts
- Hardware
- Flexguard
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Do the Lippert Flexguards Have a Different Width?
- Q&A: Tire Size for a 2020 Coleman Lantern 17B
- Q&A: Installation of Lippert Flexguard RV Slide-Out Kit Hardware
- Q&A: Is it Okay for Inner Race to Spin Inside Hub or Should it Remain Still
- Q&A: Recommended Replacement For A Suburban SW6 DE RV Water Heater
- Q&A: Will Furrion Chill Cube Fit Ducted Setup Without Air Distribution Box
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Must-Have Flat Towing Components
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV