Landing Gear Skips and Legs Wont Extend When Raising Trailer Jack
Updated 12/12/2016 | Published 12/10/2016 >
Question:
My landing gear on my 08 forest river, Sandstorm goes down ok but, when putting weight on it by extending the landing gear it clicks like the teeth in the gear box are skipping and the legs wont extend any further. Please help!!! The motor was supposedly new when we recently purchased our toy hauler and the gears seem to look ok.
asked by: Beth G
Expert Reply:
If it a jack isn't able to raise a trailer properly it's generally because it isn't getting enough power or there is hardware problem. I would first check the wiring and make sure there isn't a short. Also, inspect and clean the location of the ground. It needs to be a clean bare metal surface. Also, test the battery. It could be the motor is just fine but the battery isn't providing enough power and needs to be replaced.
If there isn't a power issue then the problem, and you've already verified the gears are okay the issue is likely the screw or nut that's inside the jack. On most jacks this not replaceable and you would need to repalce the entire jack.
Product Page this Question was Asked From
Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 7001 - 8000 lbs
- Manual Jack
- 36 Inch Lift
- Weld-On
- 2 Jacks
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: 179015
- Video: The Low-Down on the Replacement Motor for Stromberg Carlson Electric Landing Gear
- Search Results: venture landing gear motor
- Search Results: 8532~07
- Search Results: m~9000~pk
- Shop: Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor
- Shop: Replacement Switch for Stromberg Carlson Electric Landing Gear
- Search Results: awning rail
- Shop: Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Shop: Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies
- Shop: Replacement High Speed Motor for Stromberg Carlson Electric Landing Gear - 5,000 lbs
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Shop: LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Oval - Red Lens
- Q&A: Replacement Heavy Duty Motor For Landing Gear On 2010 Keystone Raptor Toy Hauler
- Q&A: Troubleshooting Landing Gear Motor that Works Slow on 2011 Keystone FZ302
- Q&A: Heavy Duty Replacement Landing Gear Motor For Venture M-9000-PK
- Q&A: Replacement 5th Wheel Landing Gear Motor for Venture 9000
- Q&A: Replacement Landing Gear Follow Leg for 2003 Keystone Everest
- Q&A: Recommended Replacement Landing Gear Set for a 2004 Keystone Cougar 5th Wheel Trailer
- Q&A: Recommended Upgraded Motor for 5th Wheel Landing Gear
- Search Results: taillight
- Search Results: optronics
- Video: An In-Depth Look at the Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear

