Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hi Kerry; the 339894 is actually still an active part. The correct replacement motor is the Replacement Electric Motor Assembly for Lippert Coach RV Steps #LC63BX which is the same as the 339894.
view full answer...The big difference is that the #HS381-8066 is for marine applications so that means it has stainless steel hardware and a marine grade gasket which allows it to stand up a lot better to corrosion than the #HBA-12.
view full answer...Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as…
view full answer...The reverse light pin on a traditional 7-way trailer connector, like part #PK11893 or a factory connector if that's what you have on your 2018 Ram, is the center pin. Take a look at the picture I attached that shows all the pin functions. To…
view full answer...Currently it appears Roadmaster only offers rear sway bars for your 2021 Newmar Baystar 3014 class A RV motorhome. Your Baystar is on the 20,500lb GVWR Ford F-53 chassis. The 1-3/4" Roadmaster Rear Anti-Sway Bar #RM25VR is the stiffer option and…
view full answer...A track bar and anti-sway bar address different issues on a motorhome. Track bars keep your vehicle's axle in line and minimize axle side play. An anti-sway bar like the #RM25VR improves stability and balances weight transfer reducing body roll.…
view full answer...No, it does not matter which wire you use for the ground and which is used for power when wiring electric brakes. Each can be used for either purpose.
view full answer...Actually all you really have to do is remove the oil from the hub and then pack the hubs with grease and then get the correct bearing buddy to match the threaded hub bore. You will need to measure the inner diameter of where the old grease cap…
view full answer...In regards to an electric over hydraulic actuator, the 1,000 psi model is for drum brakes and the 1,200 psi model is for disc brakes. The size of the axle, etc. are not factors. The most popular option we offer is the HydraStar Vented Marine Electric…
view full answer...The Dexter DX Series #K71-651 and the Hydrastar Vented Marine #HS381-8067 are more comparable as they both have hardwire installations (just made by different manufacturers) while the Dexter BrakeRite II #T4813102 is more of a…
view full answer...The seals that you would need to replace your AL-KO 1536852 seals are the TruRyde Grease / Oil Seals 10-10 (Pair) - Double Lip Seals #RG06-090. They have an inner diameter of 2.125", an outer diameter of 3.376", and are used for 5,200 lb -…
view full answer...The Fulton Safety Chain with Clevis Hook #FCHA0050324 referenced in your question features a weight capacity of 18,800 pounds. I went out to our warehouse to take a look at the chains and found that this particular rating is not stamped onto the…
view full answer...Filter Your Search
Contact and Help