Availability of Brake Assemblies that are 7 inch by 1-1/4 inch in Size
Published 11/23/2016
Products Featured in This Question
Question:
2007 triton 3 place two axle snowmobile trailer brake assemblies. i am measuring 7 inch drums and 1 and 1 quarter linings , i am measuring the steel because the linings are gone. what brake assembly is made for this trailer?
asked by: Gary
1
Helpful Expert Reply:
7 inch by 1-1/4 inch assemblies are a pretty standard size so we have exactly what you would need. The part # AKEBRK-2L would be what you need for the left side and the part # AKEBRK-2R for the right hand side.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Electric Trailer Brake Assembly - 7" - Left Hand - 2,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 2000 lbs
- Brake Assembly
- Manual Adjust
- 7 x 1-1/4 Inch Drum
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Brake and Hub Compatibility for a 2,000-lb Trailer Axle with L44643 Bearings
- Q&A: Looking For Replacement For EB01-120 And EB01-125 Brake Assemblies
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Replacement 7 inch Brake Assembly for Fiat Elnagh 320 Motorhome
- Q&A: What Brakes do I Need for My Coleman Cobalt with Rectangle Mounting Flange?
- Q&A: Options for Adding Electric Brakes to Trailer Axle without Brake Mounting Flanges
- Q&A: Replacing Dexter Idler Hub 008-258-05 with Hub and Drum Assembly # 8-257-5UC3
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Article: Trailer Lighting Requirements
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)