No Gap Between Timbren Suspension System And Axle On 2008 Chevrolet Silverado 2500HD
Updated 11/16/2016 | Published 11/15/2016
Question:
on my 2008 chevy 2500HD with Timbren GMRCK25S installed , I have little to no clearance space between it and the axle, is this ok? I have a large toolbox and a rhino bed liner in the bed didnt know if that extra weight made a difference , thanks ,
asked by: David
Helpful Expert Reply:
Per the instructions for the Timbren Suspension System, part # TGMRCK25S, on medium and heavy-duty trucks there will be constant contact and the system will have no gap.
It sounds like you have your system installed correctly and have nothing to worry about.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Overall Height of Timbren Spring Kit part # TGMRCK25S
- Q&A: Timbren Suspension Kit that Fits 2005 Chevy Silverado 1500HD
- Q&A: Timbren Kit Recommendation for 2006 Chevy Silverado 2500HD
- Q&A: Recommended Upper Doors For 1989 Jeep YJ With Steel Lower Doors And Hard Top
- Q&A: P3 Brake Control Shows No Trailer Connected Even with Trailer Connected to 2002 Ford F-150
- Q&A: Location of Brake Controller Fuse on a 2001 Chevy Silverado
- Q&A: Suspension Enhancement Recommendation for 2003 Chevy Silverado 1500HD with 2 inch Lift
- Article: How to Mount a Truck Bed Camper
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Trailer Tire Sizing
- Article: Ram Trailer Tow Prep Package
- Article: Anti-Rattle Devices
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers