Recalibrating Leveling On 2014 Mobile Suites 5th Wheel With 6 Point Ground Control Leveling System

Published 10/27/2016

Question:

After auto.level camper and it says level It is down in front lower. How do i recalibrate leveling its over a half bubble off with level

asked by: William D

Expert Reply:

I reached out to my contact at Lippert Components and he walked me though how to fix your leveling issue.

The “Zero Point” is the programmed point that the trailer will return to each time the Auto Level feature is used.
Note: Prior to starting this procedure, double check all connections on the controller, jacks, and touch pad.
1. In manual mode, run the jacks to level the trailer. This is best achieved by placing a level in the center of the trailer and leveling it both front to back and then side to side.
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button 5 times and then press and release the “REAR” button 5 times.
4. The touch pad will flash and beep and the display will read “ZERO POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER” button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is complete.
8. The system will set this point as its level state and the touch pad will turn off.