Can the Clearance Light MC65AB be Wired to a Trailer that Uses a Ground Wire
Published 10/12/2016
Products Featured in This Question
Question:
Im replacing broken lights on the high band equipment trailer so I dont know the brand/model, plus there is a mix of lighting equipment. Some with with MC65 some are red, some amber. The light I am asking about is the combined red/amber that goes over the wheels. The bracket that is there has two wires. Should I go with a different setup or is one just a ground that will not be necessary if I go with the MC65AB?
asked by: Patrick M
Expert Reply:
To install the part # MC65AB you would want to use the bracket with wiring part # A65PB which has a power wire but then grounds through the mounting hardware. If you have a ground wire on your current fender setup you can run the ground wire to the mounting hardware and be ready to go.
Product Page this Question was Asked From
Optronics Incandescent Trailer Clearance and Side Marker Light - Submersible - 2 Bulbs - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- Incandescent Light
- 3-15/16L x 1-1/4W Inch
- Amber
- Optronics
more information >
Continue Researching
- Shop: Black Bracket and Single Wire Plug for Thin Line Series Trailer Clearance and Side Marker Lights
- Search Results: a65b
- Shop: Miro-Flex Thinline LED Trailer Clearance or Side Marker Light - Sumbersible - 4 Diodes - Red Lens
- Video: Miro-Flex Thinline LED Trailer Clearance or Side Marker Light Feature Review
- Video: An In-Depth Look at the Miro-Flex Thinline LED Trailer Clearance or Side Marker Light
- Article: Trailer Lighting Requirements
- Shop: Black Bracket and Single Plug-N-Go Plug for Thin Line Trailer Clearance and Side Marker Lights
- Search Results: mc65
- Search Results: a65p
- Video: Optronics Sealed Thin Line Two-Bulb Trailer Clearance Light Installation
- Video: A Closer Look at the Optronics Bracket and Single Wire Plug for Trailer Clearance and Side Marker Li
- Video: Optronics Trailer Lights A66PB Review
- Video: In-Depth Review of the Optronics Incandescent Trailer Clearance and Side Marker Light
- Video: Review of Optronics Trailer Lights - Mounting Bracket with Plug - A65PBPG
- Q&A: Mounting Bracket Options for Optronics Sealed, Thin Line Clearance Side Marker Light # MC65AB
- Q&A: LED Version of the Bargman 99 Incandescent Clearance Light # 3499001
- Q&A: How Does the Optronics Light # MCL75RB Install on a Two Wire Lighting System
- Q&A: Replacement LED Clearance Lights for 2000 Sundowner Trailer
- Shop: Chrome Bracket and Single Wire Plug for Thin Line Trailer Clearance and Side Marker Lights
- Shop: Chrome Bracket and Single Wire Plug for Optronics ThinLine MC65 Clearance and Side Marker Lights
- Shop: Gray Bracket and Single Wire Plug for Thin Line Series Trailer Clearance and Side Marker Lights
- Shop: Optronics Incandescent Trailer Clearance and Side Marker Light - Submersible - 2 Bulbs - Amber Lens
- Q&A: Mounting Base and Wiring Harness for Optronics Clearance Light # MCL63CAB
- Q&A: Using 7-Way 12V Power Circuit to Power Trailer LED Interior Lights
- Q&A: What Type of Connector Does Black Bracket and Single Wire Plug # A65PB Plug In To