Recommended 7-Way Trailer Connector For 2017 Chrysler Pacifica

Updated 10/06/2016 | Published 10/05/2016

Question:

The T-one wiring kit 118723 that I purchased is installed. My Chrysler dealer installed same. They had also installed a factory receiver on my 2017 Pacific. The flat plug for the wiring kit 118723 is under the 2x2 inch part of the receiver. At 80 it is difficult to connect the trailer to said vehicle !! I want to purchase a male seven spade connector that I can mount to the receiver. There is an opening on the passenger side of the factory receiver to do this. I see that you have listed many adapters to do this. What do you suggest?

asked by: Jud P

Expert Reply:

To install a 7-way connector on your 2017 Pacifica you will need part # ETBC7. This plugs into the 4-way connector on the back of your vehicle.

Additional wires need to be run from the # ETBC7 as shown in the attached drawing. You can cap the wires you do not need to use. The kit does include a mounting bracket for the wiring connector you can use. If you do not want to drill holes to mount the trailer harness you can use the no-drill bracket like part # 18140.

If you need the 7-way connector because you are using a brake controller you can use the wiring diagram I provided to see how the wires are run for a brake controller as well. If you need a brake controller I recommend part # 90885. This is our most popular because it is easy to install and operate.

expert reply by: Jeffrey L