What Size Bolts Should be Used to Mount the Trailer D-Ring Tie Down, # LRB1
Updated 11/03/2010 | Published 11/01/2010
Question:
What size [diameter] bolts does this part take?
asked by: Roger R
0
Expert Reply:
I went out to the warehouse to measure the square holes in the Trailer D-Ring Tie Down, # LRB1. According to my measurements it will accept bolts no larger than 7/16 inches in diameter. A 3/8 inch bolt would probably be the most ideal size to use.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 4000 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Continue Researching
- Q&A: Comparing O-Track Cargo Control System And L-Track System
- Q&A: Recommendation for Re-Using Deck Board Screw Holes When Replacing Wood on Trailer
- Q&A: Are Trailer Wheel and Tire Combos Balanced
- Q&A: Can PingMaster 5000 Wireless Trailer GPS Tracker Battery Be Replaced
- Q&A: Bolt Hole Spacing of Demco DM16080-52 and Titan T4853100 21K Trailer Couplers
- Q&A: Mounting Hole Spacing on Buyers Products Straight Tongue Trailer Coupler 3370091562
- Q&A: Hole Spacing and Channer Dimensions of Buyers Products 3370091560 Trailer Coupler
- Article: Cargo Tie-Down Methods
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers