What Other Parts Are Needed To Tow A 2008 Toyota Tacoma With A Roadmaster Tow Bar
Updated 11/01/2010 | Published 10/31/2010 >
Products Featured in This Question
Question:
Hello I have a Road Master 5000 tow bar that I am going to use to tow my 2008 Tacoma. It has the quick connect pin and socket system. Can you set me up with all the hardware I need to get me on the road. In the past, I used the square tubing pin pocket type. I would prefer to have the pockets run through the bumper area instead of underneath. 2008 Tacoma double cab Thanks for your help
asked by: Bryan T
Expert Reply:
The Roadmaster 5000 (Tracker) Tow Bar is compatible with the Roadmaster XL Base Plate Kit # 1175-1, and will fit your 2008 Toyota Tacoma Double Cab as long as it is not an X-Runner model. The base plates will install underneath the bumper (see picture to the right). I do not have any tow bar base plates that will install through the bumper.
You will also need safety cables should the tow bar become disconnected. These are required by law across the country. The safety cables you will need are the Roadmaster Safety Cables # RM-645.
For lighting, you can wire your vehicle using Roadmaster Universal Diode Wiring Kit # RM-154. The other option would be to use Magnetic Towing Light Kit # RM-2120, which are lights that attach to your vehicle using magnets. If you are going to be towing your Toyota Tacoma often I would recommend using # RM-154, as you would just plug in your vehicle after the initial install. I am sending a video link of this wiring kit being installed on a 2006 Jeep Liberty. The vehicle is different, but the wiring principle is the same.
You will want to check with the manufacturer for instructions on the proper procedure for towing your 2008 Toyota Tacoma because some vehicles must be equipped with a transmission lube pump, an axle disconnect, drive line disconnect, or free-wheeling hubs before they can be towed.
Product Page this Question was Asked From
Roadmaster Crossbar-Style Base Plate Kit - Removable Arms
- Tow Bar Base Plate
- Removable Draw Bars
- Hitch Pin Attachment
- Partially Hidden
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: 2007 Toyota Tacoma Base Plate Kit Options to Fit with Roadmaster Tow Bar
- Article: Can You Flat Tow a Toyota Tacoma?
- Q&A: Dimensions of Roadmaster Tow Bar Adapters # RM-031 and # RM-034
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Full Flat Towing Set Up For A 2026 Jeep Gladiator Sahara
- Article: Best Vehicles to Flat Tow Behind an RV



