Mount: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles on a 2006 Jeep Liberty Video

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The Tow Ready Vehicle To Vehicle Taillight Converter, #118158, you have referenced will not be needed since you will be staying with a 3-wire system (separate stop and tail lights)on both of your vehicles. The converter is only needed if you had a…

It sounds like you have a charge line ran from the RV's battery to the trailer's battery. If this is the case then yes, you will need a current limiter (circuit breaker) in between the two in order to prevent any spikes that could in turn…

The Hopkins Custom Tail Light Wiring Kit for Towed Vehicles part #HM56202 will not work on your 1997 Jeep Wrangler TJ because Jeep changed the pinouts on the tail lights between the 1997 and 1998 model years. Therefore, it will plug into the…

While we don't carry the Dometic brand of RV AC units we do have the Advent Air RV AC Unit part #ACDOM150B which plugs right into the same connectors as your Dometic which gives it a very easy install. This also will allow you to use the same…

To flat tow a vehicle, you need a tow bar, base plates that mount to the vehicle and provide an attachment point for the tow bar, safety cables, a lighting solution and a supplemental braking system. The base plates I recommend for your 2003 Jeep…

The safety cables I recommend the most are #RM-643. They are coiled but stretch out to 68 inches. The coiled design helps keep the cables off of the ground. If you want to go longer I recommend #RM-653. These are 80 inches long.

Yes, the Replacement 3/4" SC Spec Flip Bolt #RM-350199-00 will also fit the Roadmaster Falcon All Terrain, Non-Binding Tow Bar #RM-522. I recommend also changing the Replacement 3/4" Lock Nut #RM-350267-01 when you change the bolt.

I'm assuming you're speaking of the 3/4 inch bolt and nut that joins the yoke to the stinger assembly, which are items #14 and #15 as shown in the provided diagram. If that's what you're speaking of, then yes we do offer that nut and…

Manufacturers do not list the steps they use on their RV's so you'll have to measure the entry height (ground to the mounting bracket for the steps) and mounting bracket width to know what steps are the correct fit for your 2008 Tiffin…