Is it Possible for E-Track and Snowmobile Carbides to Scratch Each Other
Updated 09/12/2016 | Published 09/10/2016 >
Products Featured in This Question
Question:
Hi I just purchased a 8 1/2 foot X 27foot enclosed snowmobile trailer. I am considering 2 full lengths of E-Track, spaced equally, for tie downs on the floor. My concerns are will the ski carbides damage the E-Track and/or will the E-Track damage the carbides? also will the track studs picks damage the E-Track and/or will the E-Track damage the track studs and/or track? There will not be any way to prevent both from happening. Thank you for input, thoughts and ideas.
asked by: Kevin
Expert Reply:
From what I understand about snowmobiles, and please correct me if I am wrong because I have little knowledge on them, the carbides are the part the skis attach to. Is that correct? I am not sure how the E-track or the carbides would come into contact with each other. But if they did then it would be possible for one to scratch the other.
To avoid that you could use 3 lengths of tracks; one on the far left side and one on the far right with one in the center between the snowmobiles so that the E-tracks are spaced wider than the width of the snowmobiles.
Once the tracks are installed you can use D-Rings # 59131 that mount to the E-Track and create nice tie down points for straps.
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1
- E Track
- E Track Rails
- Horizontal
- 5-1/8 Inch Wide
- 2000 lbs
- 5 Feet Long
- Erickson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Q&A: Tips for Installing E-Track on a Trailer with Tube Aluminum Frame
- Q&A: Differences Between Different Brands of E-Track
- Q&A: Can E-Track Be Used To Secure a Car in a Trailer?
- Q&A: Factory 30 Amp Fuse for Trailer Brake Control vs Auto Resetting Fuse on a Ford F-150
- Q&A: Are the Erickson Horizontal E-Tracks Strong Enough for a 5,000 lb Vehicle
- Q&A: Factory Integrated Trailer Brake Controller Setup on a 2011 Chevy Silverado
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Tire Sizing
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Hand Winches
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft


