Trailer Right Turn Signal Not Working When Connected to a 2000 Ford Ranger
Updated 08/25/2016 | Published 08/24/2016
Products Featured in This Question
Question:
The signal wire from the right turn signal is disconnect somewhere in the vechicle, so where does the green wire start from in the 2000 ford ranger? I put all new wiring harness on boat trailer and it still does not work.
asked by: Ken
Expert Reply:
If your 2000 Ford Ranger has the factory trailer connector then there is a fuse for the trailer right turn and brake light located in the in cab fuse panel in location 7. But if this fuse is blown then the right brake light on the trailer also would not work.
If you have an aftermarket wiring harness such as # 118344 then it ties into the tail light wiring on your Ranger. Otherwise you would have to follow the wiring as far forward as you can and fix any broken or pinched wires.
I have included a link to our help article on testing wiring for you as well.
Product Page this Question was Asked From
Submersible, Under 80" Trailer Light Kit with 25' Wiring Harness
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- License Plate
- Marker
- Square
- Surface Mount
- Submersible Lights
- Incandescent Light
- 5L x 4-1/2W Inch
- Amber
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Looking For 13" Wheel To Match Those Currently On Trailer
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Will A Spare Tire With A Higher Load Rating Be Ok On A 2022 Aluma 7814ST?
- Q&A: Replacement for a Klauber 500 Series Slide-Out Motor
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How to Measure for a Replacement Axle, Hubs, and Leaf Springs for a Boat Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Will ThermaHeat RV Holding Tank or Step Heater Pad Help With Cold Weather Camping
- Q&A: 6k Hub Drum that Can Fit Timbren Axle Less Kit part # ASR1THDS03
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Correct Axle and 13 Inch Tire and Wheel Kit for Homemade Trailer with 58 Inch Spring-Centers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)