Parts Needed to Flat Tow a 2009 Chevy HHR  

Question:

Expert Reply:

We do offer an adapter to allow Roadmaster base plate brackets to fit other brands of tow bars, including Draw-Tite, Reese, Valley, Tow Ready and EAZ-Lift. Roadmaster Adapter part # RM-025 will work with Roadmaster base plates and the above brands of tow bar.

For a base plate you would then want the part # 3141-1 which is a confirmed fit for your 2009 Chevy HHR. I attached an install video for you to check out as well.

For lighting you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.

And finally, most states now require supplemental braking in the vehicle being flat towed. The easiest system to set up and use is the Blue Ox Patriot # BLU37TR, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.

Most likely you will also need a high low adapter so that the tow bar will be level when you are flat towing. I attached a link to a page that has all of the ones we carry.

I have included a couple of helpful links to our articles on flat towing for you. Be sure to consult the vehicle owners manual for more specific information on flat towing your vehicle.

expert reply by: Jameson C

0