Could the Brophy D-Ring Anchors part # LRB1 Get Welded to Trailer Frame
Published 08/22/2016
Question:
i was thinking of purchasing Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8inch Wide - Surface Mount - 4,000 lbs Code: LRB1. Its main use would be to tie down a 600 pound quad in an open trailer. Can I just weld this D-ring to the frame instead of bolting them down on wooden floor? Thanks
asked by: Emerson
Expert Reply:
You definitely could weld the Brophy D-Ring Anchors part # LRB1 to your trailer frame if you wanted to install them. You would just want to make sure that you are in a well-ventilated area as these are zinc coated.
I attached an install video for you to check out that shows them getting bolted on as well.
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 4000 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are Trailer Wheel and Tire Combos Balanced
- Q&A: Replacement Inner Tube Gooseneck Coupler 4" Diameter For BullDog Bx1 25k
- Article: Cargo Tie-Down Methods
- Q&A: Comparing O-Track Cargo Control System And L-Track System
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Center Cap for Trailer Wheel With 5 Inch Pilot Hole Diameter
- Q&A: Chrome Wheel Center Cap for 5-1/8 Inch Diameter Pilot Hole
- Article: Converting Your RV Water Heater to Tankless
- Q&A: Offset of Wheel/Tire Combo # AM34964 Does it Include Center Cap and Lug Nuts
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers