Is Cut Trailer Wiring Difficult to Reattach
Published 07/14/2016
Question:
If the has brakes and some one cut the wires is hard to fix
asked by: Robert M
0
Expert Reply:
I hope they didn't cut the wires as a way to get revenge on you...
It's not hard to reattach trailer wiring though. Just use solder and electrical tape or butt end connectors. If the wires were cut the colors would match right up as well as the lengths.
I attached a help article that has diagrams and more info on trailer wiring in general.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
3" Round Trailer U-Bolts (Qty 2)
- Trailer Suspension Parts
- U-Bolts
- Camper
- Car Hauler
- Utility Trailer
- 5200 lbs - 7000 lbs
- Round Axle - 3 Inch
- 1/2 Inch Diameter
- 7 Inch Long
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: 008~201~05
- Search Results: 031~030~02
- Search Results: 031~032~02
- Search Results: 25580
- Search Results: 010~054~00
- Video: Review of the Suspension Kit for Tandem-Axle Trailers
- Shop: Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs - 2-1/4" Links
- Shop: Dexter Trailer Hub and Drum Assembly - 5,200-lb E-Z Lube Axles - 12" - 6 on 5-1/2
- Search Results: dexter equalizer
- Search Results: spring seats
- Q&A: Is Radius of Round Trailer U-Bolts part # SP01-060 Round or Flat
- Shop: U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles - 7" Long U-Bolts
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 86-1/2" Long - 5,200 lbs
- Video: Detailed Breakdown of the Replacement U-Bolt w/Nuts for 8,000-lb, Round Trailer Axles
- Shop: Dexter Trailer Hub and Drum Assembly for 5,200-lb Axles - 12" Diameter - 6 on 5-1/2
- Shop: Trailer Hub and Drum Assembly - 5,200-lb Axles - 6 on 5-1/2
- Shop: Dexter Trailer Hub and Drum Assembly - 5,200-lb and 6,000-lb Axles - 6 on 5-1/2 - Pre Greased
- Video: Dexter Trailer Hub and Drum Assembly Spec Review
- Video: Let’s Check Out the Dexter Trailer Hub and Drum Assembly
- Q&A: Bearing Kit & Seal For Dexter 031-030-02, 031-032-02 Bearings
- Q&A: Does the Axle Need to Be Supported When Replacing U-Bolts on a Trailer Axle
- Q&A: Where are Axle U-Bolts Measured From
- Q&A: Longer U-Bolts For 3 Axles For Roadmaster Roadmaster Comfort Ride
- Q&A: Replacement Dexter D52 Trailer Axle with 86.5" Hub Face Length
- Q&A: Determining Correct Replacement Equalizers and Shackle Straps for Older Trailer
- Video: How to Install the etrailer Electric Trailer Brakes on a 2009 Carriage Cameo Fifth Wheel
- Video: etrailer VS Dexter Self Adjusting Brakes Comparison
- Video: Hands-On with the Dexter Trailer Hub and Drum Assembly