bing tracking image
Q & A Icon

Constant Power on Blue Trailer Brake Wire After Installing 7-Way on 2012 Nissan Frontier  

Updated 08/14/2026 | Published 07/14/2016

Question:

I HAVE A CURT TRAILER WIRE C56226 THAT PLUGGED RIGHT IN TO MY 2012 FRONTIER BUT THE BLUE TRAILER BRAKE HAS A CONSTANT 14VOLTS GOING TO IT. MAYBE THE RELAY IS NOT WIRED RIGHT?

0

Expert Reply:

On wiring harness # C56226 the larger brown relay is for the 12 volt circuit on the 7-Way and the two smaller blue relays are for the turn signal circuits so none of them would cause the constant power draw on the blue brake wire but I think I know what the problem is.

On some Nissan vehicles the connectors where the 7-Way plugs in are wired differently than on other Nissan vehicles. To fix the issue you can swap the blue and black wires on the harness that plugs into the vehicle.

expert reply by:
0
Michael H
Holly D. profile picture

Holly D.

11/8/2021

Can someone please be more specific about HOW you get the blue and black wires out of the plug to switch them. I cannot figure it out and I don't want to break the plug.

Les D. profile picture
Etrailer Expert

Les D.

11/11/2021

Regarding the Curt # 174188, I don't think it was manufactured with an allowance for changing the wiring. Next, I don't know if I would change the wiring on the truck side. If you do the truck will be wired wrong for all OTHER trailers you want to connect. I would make any wiring swaps at your trailer if neccessary. At that point you could use the Hopkins # H20046 pigtail.
John S. profile picture

John S.

8/14/2026

If you get constant power to your brakes like I did, then you can switch the black and blue wires on the provided wiring harness (they go into the black connector). I depinned them by sticking a small pick into them and pressing a small plastic tab, which allowed the metal connector to easily slide out. Be sure to take a pic or mark which side is which.

Claire H. profile picture
Etrailer Expert

Claire H.

8/14/2026

@JohnS Swapping the blue and black terminals is an accepted fix for a specific issue found on some Nissan vehicles. On certain Frontiers, Xterras, and Pathfinders, the factory connector has the 12V auxiliary-power and electric-brake-output circuits reversed. That results in constant 12V being sent to the trailer brakes, causing them to stay applied whenever the trailer is plugged in.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>