Trailer Clearance Light Part # A91RB Installation
Published 09/20/2010
Products Featured in This Question
Question:
Not sure how to connect this light to my trailer with the single wire plug pigtail. I see that the light is self-grounding, but I do not see any place to plug the power wire. I know which trailer wire to tap into with the pigtail wire, but how does it connect to the light? Thanks
asked by: Greg
Expert Reply:
To connect the Optronics Red Mini Rectangular Trailer Clearance and Side Marker Light to your existing trailer wiring, you would need the pigtail which is part # A91LW if you were using the self grounding mounting bracket, part # A91BB.
If you were using some sort of other bracket that is not self grounding, a two wire pigtail is offered, part # A46PB.
Product Page this Question was Asked From
Optronics Trailer Clearance and Side Marker Light - Submersible - Incandescent - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- Incandescent Light
- 2-1/2L x 1-3/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: What Lock Kit Is Needed For My B&W Pintle Hitch?
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Q&A: Clips and Clamps to Attach Wires and Wiring Harnesses to the Bottom of a Trailer Frame
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Q&A: What Brake Controller For 2020 Chevy Colorado & Is There Plug-In Harness
- Q&A: Installation of Nev-R-Lube Bearing
- Q&A: Replacement Magnets for Dexter 12-1/4 x 4 Electric Trailer Brake Assemblies
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers