Hitch Pin Clearance Measurements for Curt Front Mount Trailer Hitch Licenese Plate Holder
Updated 09/03/2010 | Published 09/02/2010
Question:
Hello. What is the distance from the back of the plate holder to the hitch pin hole? Thanks.
asked by: Ray
0
Expert Reply:
Curt provides 2 hitch pin holes on the License Plate Holder so you can set it to a different depth depending on your bumper size and shape. The first hole measures 4-1/8 inches from the back of the plate to the center of the hole. The second hole measures 6-1/8 inches from the plate to the center of the hole.
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch License Plate Holder
- Accessories and Parts
- Front Receiver Hitch
- License Plate Holder
- CURT
more information >
Continue Researching
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Q&A: Can Rhino-Rack CXB Legs Be Used with 3030 Aluminum Extrusion?
- Q&A: Recommended Dinette Cushions and Jackknife Sofa in Dellmead
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Replacement RV Propane Gas and Carbon Monoxide Detector for a Expired RVCOLP-2 Detector
- Q&A: Recommended Bearing Buddies for a CE Smith Trailer Axle Beam with Idler Hubs
- Q&A: Recommended Replacement for a Nova Kool 4500 4.3 Cu Ft Refrigerator
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: Brake Controller Installation: Starting from Scratch