Hitch Ball Reducer Sleeve for Ram 2500 Pickup
Updated 06/01/2016 | Published 05/29/2016
Products Featured in This Question
Question:
i had a 2500 Ram 2010. I motice my new 2015 ,has a wider space where the hitch ball goes attached. I need to replace it, this way it will be tight as shoul be. Without any room to move and create excesive noise. I saw a new one like mine, with the one brindes Reese and booth para fits perfecto. Hitch ball and the arm wich is Wider this usar. Ley me know if you hace ir available. Thanks.
asked by: Eric G
Expert Reply:
It sounds like you need a spacer for your hitch ball. If your ball has a 1-inch shank and the ball mount has a 1-1/4-inch opening, use Reese part # RP80106 or Curt part # F-2.
Product Page this Question was Asked From
Curt Ball Mount for 2" Hitches - 1" Rise, 2-1/4" Drop - 7-5/8" Long - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- CURT
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Is There A Trailer Jack That Uses Bearings For The Swivel Wheel?
- Q&A: Difference Between Redarc Tow-Pro Liberty RED68CR And RED72CR For A 2017 Toyota Tacoma
- Q&A: Replacement Swivel Jack w/a Wheel for a Boat Trailer
- Q&A: Replacement Grease Seal for DL-225-53
- Q&A: Curt C96GJ Wiring Kit Compatibility With Factory 4-Pin On 2025 Ford Ranger
- Q&A: Recommended Torque for Tightening Curt Hitch Balls to Ball Mount
- Q&A: Wear Sleeve For A 3500 Pound Dexter E-Z Lube Axle On A Travel Trailer
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: The 5 Best Trailer Drop Hitches You Can Buy