Is The Draw-Tite 75091 Class III Trailer Hitch Same as OEM Hitch On A 1998 Toyota 4Runner
Published 08/20/2010
Products Featured in This Question
Question:
is this the same hitch that would have been installed at the factory? 1998 Toyota 4Runner
asked by: chris
Expert Reply:
The Draw-Tite # 75091 Class III trailer hitch was not the factory hitch on the 1998 Toyota 4Runner.
The Draw-Tite is a Class III trailer hitch that has a towing weight capacity of 5,000 lbs. and a tongue weight capacity of 500 lbs. It attaches to existing holes in the frame. If your vehicle has tow hooks, then the tow hooks do have to be removed to install the hitch.
For towing you will also need the Curt Ball Mount # C45010, the Pin and Clip, # PC3. The hitch ball will be either the 2 Inch Hitch Ball, # 19247, or the 1-7/8 Inch Hitch Ball, # 19260.
If you need a trailer connector at the rear of your vehicle you would use the Tekonsha T-One Wiring Harness, # 118341.
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hitch for a 2001 Toyota 4Runner w/ a Larger than Stock Tire
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Hitch Recommendation for a 2001 Toyota 4Runner that Doesnt Interfere with Spare Tire
- Q&A: Recommendation For Adding A Hitch To A 1996 Toyota Prado JDM
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Wiring Harness For 2000 Toyota 4Runner
- Q&A: Recommended Trailer Hitch Receiver And Accessories For Towing With A 1998 Toyota 4Runner
- Q&A: Replacement Hardware Kit for Draw-Tite Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)