Will Curt Tube Cover, # I-728, Fit A Factory Installed Hitch On A 2010 Ford Explorer Sport Trac
Updated 08/19/2010 | Published 08/18/2010
Question:
Will the subject cover fit a factory installed 2 Ford trailer hitch on a 2010 Explorer Sport Trac? The inside measurement of the hitch appears to be 2 1/16.
asked by: nan
Expert Reply:
The Curt Rubber Tube Cover, # I-728, is made to fit all 2 inch hitch receivers. The factory hitch on your 2010 Ford Explorer Sport Trac will be a 2 inch hitch.
Trailer hitches are only made in 1-1/4 inch, 2 inch and 2-1/2 inch sizes. The 2-1/2 inch size would be used only on large trucks and vans.
A nice feature on the Curt hitch cover is that it has a storage port for your 4-pole trailer connector molded into the rubber ring that holds the cover on to the hitch.
Product Page this Question was Asked From
Rubber Tube Cover for 2" Trailer Hitch Receivers
- Hitch Covers
- Misc Covers
- Plain
- Rubber
- Fits 2 Inch Hitch
- Standard
- Square
- CURT
more information >
Continue Researching
- Q&A: Why Does the etrailer Trailer Hitch part # e72AR Have a Higher Towing Capacity than the Vehicle?
- Q&A: Can the Center Knockout Panel be Re-Installed After a Trailer Hitch on a 2015 Cadillac SRX
- Q&A: Will Magnum Headache Rack Fit with Pace Edwards SwitchBlade
- Q&A: Hitch and Scooter Carrier with Ramp Recommendation for 2023 Acura RDX
- Q&A: Curt or etrailer Hitch for 2026 Honda CR-V Hybrid
- Q&A: Choosing Between Curt, etrailer, and Draw-Tite Hitches for 2024 Toyota Venza LE Hybrid
- Article: How to Measure for Trailer Hitch Drop
- Article: Which Hitches are Made in the USA
- Q&A: Is There A Product That Helps Protect A Vehicles Paint From Roof Rack Feet/Towers?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Article: Anti-Rattle Devices
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com