Availability of Rubber Socket to Grab Trailer Door Stop
Updated 04/11/2016 | Published 04/07/2016
Products Featured in This Question
Question:
I am looking for the socket that will fit the bolts used to hold the latch bars on the rear door of an enclosed trailer Thanks for any help in locating
asked by: David J
0
Expert Reply:
Sounds like you are looking for the Plunger and Rubber Socket Door Holder - 1-3/4" Long Plunger # PLR62-66. For just the socket you would use # PLR66.
The part # 37210715 you asked from is a 2-1/2 inch diameter door stop that is designed to prevent your door or ramp from banging into the side of your trailer. I attached a review video for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Rubber Bumper for Enclosed Trailer Ramp Door - 2-1/2" Diameter
- Trailer Door Parts
- Ramp Door Bumpers
- Round Bumper
- Bolt-On
- 2-1/2 Inch Wide
- Rubber
- JR Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Is there a 9' Long Piece of the P&F Products Drip Rail for Enclosed Trailers?
- Q&A: Suspension Upgrade on a 2016 Keystone Cougar XLite 5th Wheel
- Q&A: Plate To Allow Rolling Over Lip Of Trailer Ramp Door - Rustproof Aluminum
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Jack Recommendation with Drill Adapter
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Troubleshooting Compressor for Firestone Air Springs that Won't Shut Off
- Q&A: Transition Plates For Trailer Ramp Door That Is 80-1/2" Wide
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: VCC Pickup and Dropoff
- Article: What Do I Need To Tow A Trailer?
- Article: Ram Trailer Tow Prep Package