Will "Junior" Locking Stainless Steel Flush Door Latch Fit Trailer Door is Correct Hole Size Is Cut
Updated 04/08/2016 | Published 04/06/2016
Question:
I have an enclosed cargo trailer. Id like to ad a stainless flush mount latch so I can close it from the inside. Will one of your latches work if I cut out an appropriate size hole ?
asked by: John
0
Expert Reply:
All you would need to do to install the part # L1883 that you referenced is cut the appropriate sized hole. For this latch you would need a hole that measures 3-5/8" tall x 4-3/4" wide.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
"Junior" Locking Stainless Steel Flush Door Latch
- Trailer Door Latch
- Reversible
- Flush Latch
- Keyed Unique
- Built In Lock
- Bolt-On
- Stainless Steel
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is There An Offset Gooseneck Ball For 2017 Ram 2500 With Factory Puck System?
- Q&A: Need Replacement For UFP PG1090 Actuator On Magic Tilt Single Axle Trailer
- Q&A: Replacement Bargman L-300 Locking Latch
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: Recommended Entry Door Latch For A Horse Trailer Mid-Tack Room
- Q&A: Why Would a Wheel Bearing Race Spin In the Hub
- Q&A: Installing Flush Mounted Latch on Drawers with 3/4 Inch Face
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Gooseneck to 5th Wheel Adapters
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: Trailer Wiring Diagrams