Is there a Way to Lock D-Ring Shackles to Front Of Jeep Wrangler Bumper
Updated 03/28/2016 | Published 03/25/2016 >
Question:
Hey guys, hows it going there! Im looking for a way to prevent the theft of my screw in pin that secures my D ring shackle? It does have a hole in the end and I was wondering if you have a wire type device that I could utilize to prevent some ass from stealing it. :
asked by: Christopher M
0
Expert Reply:
Most Jeep guys leave the D-rings inside the Jeep or torque down the pins so tight that it would take a very determined thief to get them. You can also try a thread locker like the part # LT37420 to make them even harder to remove.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube
- Lubricants Sealants Adhesives
- Sealant
- Nut and Bolt Sealant
- 0.2 oz
- Loctite
more information >
Continue Researching
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Q&A: Replacement Foot For Leveling Leg On 2022 Montana High Country
- Q&A: Blue Ox Base Plate and Tow Bar Wiring for 2025 Jeep Wrangler Rubicon
- Q&A: Best Blue Ox Flat Tow Setup for 2026 Jeep Wrangler
- Q&A: Roadmaster Comfort Ride Leaf Spring Suspension Kit for CrossRoads Elevation TF3612
- Q&A: Installing A Replacement Foot Pad For Lippert Hydraulic Ground Control Level System
- Q&A: Parts Needed For Flat Towing A 2012 Honda CR-V
- Q&A: How To Troubleshoot Surge Brake Actuator On a Boat Trailer
- Article: How to Mount a Truck Bed Camper
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Trailer Wiring Diagrams
- Article: Best Bike Racks for Electric Bikes
- Article: Rooftop Cargo Carriers
- Article: Thank you!

