Where Should a 14 Foot Jon Boat Set on the Roller Bunks: Flat Area or on the Rib
Updated 03/18/2016 | Published 03/16/2016
Products Featured in This Question
Question:
Where should a 14 foot jon boat set on the roller bunks in the flat area or on the rib
asked by: Clyde D
0
Expert Reply:
If the trailer has bunks now then you would place the roller bunks # DL21741 on them or in the same place using brackets # DL21742 so that the boat rests in the same location as it did before. But if it were me I would position them so the boat rests on the bunks on the flat part and not the ribs.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers
- Boat Trailer Parts
- Bunks
- Rollers
- Roller Bunk
- Rubber
- Dutton-Lainson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Roller Bunk Recommendation for a Boat Trailer With 8 Feet Bunks
- Q&A: Does Dutton-Lainson Boat Trailer Roller Bunk Come In Galvanized Version
- Q&A: Recommended Roller Bunks Replacement for Wooden Bunks for G3 1860 Boat
- Q&A: Recommendation for Roller Bunks on a Boat Trailer with 8 Foot Carpet Bunks
- Q&A: Identifying Dexter Axle Over 10,000 lbs
- Q&A: Comparing Fulton XLT and Dutton Lainson 2 Speed Winch
- Q&A: Weight Capacity And Parts Needed For Modifying Boat Trailer For 26 Ft Regal Commodore
- Article: The Basics of Boat Trailer Bunks: Bunks or Rollers?
- Article: Boat Trailer Guides: Which are the Best?
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Install E-Track in 3 Easy Steps
- Article: Most Popular Wheel Bearings